Overview

Overview

The HyDip Fuel Tracking X2 (HFTX2) is an 'all-in-one' device for fuel dispensing and tank gauging. It has all the electronics to connect nozzles, flowmeters and pumps already built in. Once connected to the internet, tank dip activity as well as fuel dispensing activity can be monitored, configured and managed via the HyDip website.

Features

• Fuel dispensing in Standard mode and Load out mode (Fast dispensing for large quantities of fuel).
• Tank gauging.
• Internet communication via 3G/4G as well as via Ethernet.
• GPS.

Dimensions

Connectors

On the main board:

On the addon board:

Wiring

Nozzles - Any:

Flowmeters - Reed switch, one phase:

Flowmeters - Reed switch, two phase:

Flowmeters - Hall effect, one phase:

Flowmeters - Hall effect, two phase:

Pumps - Any:

Sensors - 4-20mA:

❗️

Electrical safety

Please follow these guidelines to ensure safe connections:

• The HyDip device should be installed by a certified electrician.
• Follow all local codes for safety requirements. Pay particular attention to electrical codes.
• Ensure there is a good electrical connection between the HyDip enclosure earth terminal and back panel chassis.
• Use shielded cabling for all communication cables, ensuring the cable shielding is properly grounded.

Internet

Ethernet - For ethernet connection to be established it is enough to simply plug in an ethernet cable from the HyDip device to a router prior to device's power up. The connection will be configured automatically.

3G / 4G - Open the back enclosure of the device, find a SIM card slot as shown below and insert a SIM card with IP data traffic enabled and PIN disabled.

Power on the device and set up your SIM card's network details. Use the Menu and arrow buttons to select Service Menu > Settings > Network > 3G/4G-LTE > Preset . Then choose your network, and press ENTER. The device will automatically attempt to connect using the new 3G/4G connection until it succeeds.