Overview

The HyDip Tank Gauging 2 (HTG) device provides dip measurements of fuel storage tanks at both attended and unmanned remote locations. Once connected to the internet, tank dip activity can be monitored, configured and managed via the HyDip website. These devices support 3G/4G mobile, Ethernet, Bluetooth, XBee and USB connectivity

Features

Sensor readings
Internet communication via 3G/4G as well as via Ethernet.
GPS.

Dimensions

Dimension	mm
Width	180
Length	170
Height	57

Connectors

On the left side:

Connector label	Function	Connects with
CELL	3G/4G Internet connection	SMA/M Antenna
GPS	GPS Antenna connector	SMA/M Antenna
SIM	Slot for standard SIM card (with PIN disabled)	Not applicable -
ETH	Internet via Ethernet port	RJ45 Ethernet cable
USB	A USB port to connect the device to a Computer	USB Type B cable
RST	Reset / Factory restore	Not applicable -
RADIO	An antenna connector for XBEE	SMA/F Antenna

On the right side:

Connector label	Function	Connects with
EXT+/SOL+/GND	External power connector. For both EXT (external) and SOL (solar) inputs. The + marking denotes the positive terminal. GND is ground.	3 Pin Green block
BATT/GND/NTC	Battery connector. BATT is + and GND is ground. NTC is for the use of a thermocouple to prevent the battery being charged outside of the temperature range. This is an optional input.	3 Pin Green block
TK1+/TK1-	4-20mA sensor input #1	2 Pin Green block
TK2+/TK2-	4-20mA sensor input #2	2 Pin Green block
TK3+/TK3-	4-20mA sensor input #3	2 Pin Green block
TK4+/TK4-	4-20mA sensor input #4	2 Pin Green block
ON/OFF	Power switch . Unplug all sources of power for a full shutdown .	Not applicable -

Wiring

Wiring as per connector descriptions above.